Ily SATA DVD/CD Duplicator Controller Bedienungsanleitung

SATA DVD/CD Duplicator Controller User’s Manual Version 2.0

4. Copy + Compare – This command will perform the copy process, and immediately follows with a comparison between the master disc and the copied disc(

96. Compare – This command compares copied disc(s) to the master disc and ensures that the copies are exact duplicates of the master disc. This comman

or and press ENT to set audio CD burning speed or and press ENT to set DVD burning speed or and press ENT to set DVD DL burning speed 8. Source Sel

6. Drive Info: Checks the make, model, firmware and the channel (port) of the drive(s) that are connected to the duplicator controller. Press ENT Pres

122. Auto Start: Set the amount of time before the duplicator will automatically start the selected command ranging from OFF (no auto start) to 99 sec

7. Compare Speed: Sets the speed at which the master disc is compared with the copies disc(s). The speeds for CD are: 1, 2, 4, 8, 10, 12, 16, 20, 24,

2. Disc => Image: Transfers the information from the master DVD/CD to the HDD. After the image(s) transfer is complete, the reader drive is ejected

15 Press ENTPress ENTSelect the image file to be deleted or to change to Yes and press ENT to confirm. 156. HDD Info: Shows number of im

16 b) Synchronous: Loads the image at the same time while the duplicator is making copies from the master disc to the blank discs. As the co

Chapter 3 Troubleshooting:Follow these simple steps for quick and proper troubleshooting. 1. Power does not turn on or unit receives no power.a. Che

TABLE OF CONTENTSChapter 1 Introduction 1 10.Setup 11 11.HDD Manager 13LCD Front Panel Overview 1 o Start-up Menu11o Select Image 13Hardware Installa

Chapter 1 Introduction:Thank you for purchasing this SATA DVD/CD Duplicator Controller. This controller is specifically engineered to run a stand-alon

Hardware Installation Guide: Connect drives with cables provided to the appropriate slot on controller as indicated below.

Configuration Guidelines: Next are the basic operation guidelines on how to set SATA devices including optical reader, writers, and/or hard drive. Th

9 UTILITY 9.1 Pre-scan Performs a scan on the master disc before the copy process starts and ensures the master disc can be copied in the duplicat

5 11 HDD MANAGER The management for various functions of the hard disk drive (HDD).Note: For this function and sub

Chapter 2 Functions:There are two operational function modes available. One is “User Mode” which has the most frequently used duplicator functions. Th

4. Use the scroll buttons to select the command “2. Test” and press the ENT button. The drives will automatically close trays and begin the test pro